|
This module supplements the ultimate limit state checks found in
the basic software packages and includes the following system
designs:
- Limiting the concrete compressive stresses
- Limiting the reinforcing steel stresses
- Minimum reinforcement for the crack width limitation
- Crack width calculation
for following standards:
The internal forces are derived from the characteristic, frequent
or quasi-continuous combination depending on the requirement class.
The stresses are then checked and displayed based on the
load-bearing capacity reinforcement. The minimum reinforcement for
the crack width limitation is also determined and, if necessary,
increased until the required crack width is maintained.
For each combination different design situations can be defined
for the construction and end states. Each check is carried out for
all the situations of a combination.
The checked stresses and reinforcements can be displayed
graphically or in table form.
|
